|
The Situation
Is Your New(er) Heating and Air Conditioning System Not Delivering the Savings You were Promised or Were Expecting?
Many air conditioning and heating systems (new and old) do not operate according to design of the manufacture. They do not save the energy they were designed too.
WHY?
According to the National Comfort Institute, the average residential air conditioning system performs only at 57% of its effective efficiency!
What does this mean to you?
1) If your air conditioner was not properly installed or did not receive the proper start-up and testing procedures as recommended by the manufacure, then your system is not operating at its full potential!
2) It means that a typical air conditioning system with a 13 S.E.E.R manufacturer's efficiency rating is operating about a 7.41 S.E.E.R. If this were a typical 4 ton capacity system it would be is operating at only 2.28 tons!.
3) It means poor return on your investment-your comfort costs more because you probably did not get what you paid for.
These are some of the biggest reasons that some consumers and contractors unfortunately believe "Bigger is Better", when in reality, Bigger Is Not Always Better.
|
The Problem
(Some of them at least, according to the Californina Energy Commission)
Problem#1
Although California law requires contractors to obtain a permit for the installation of new or replacement HVAC equipment, 90% of installed A/C systems are done without a legally required local building permit issued, meaning that only about 10% of HVAC systems are inspected by the local building department to ensure proper current code compliance.
Problem #2
30 to 50 percent of new central air conditioning systems are not being properly installed.
As a result, Californians pay a large price for the lack of quality installation and maintenance, with commensurate poor performance.
Problem #3
Many HVAC contractors fail to ensure quality at the time fo the cooling system installation. This results in a 20 to 30 percent increase in the peak energy needed by systems to provide you wiwththe cooling and comfort demanded on hot summer afternoons. This has been accompanied by an estimated 30 percent increase in carbon emissions.
Problem#4
Poor quality maintenance after an air conditioning and heating system is installed (even if the system was installed properly) will have a great effect on efficiency, comfort and performance.
Reference:
California Long Term Energy Efficiency Plan, Sept. 2008- HVAC Sec.6. |
The Solution
Can We Increase your Heating and Air Conditioning Systems Efficiency Without Replacing Your Equipment?
We Believe We Can!
Sounds good? Of course it does!
How does your system Score?
We offer to you a set of system profiling diagnostic tests that will "Score" your system to determine what it's ultimate "Effective Efficiency" or actual delivered performance compared to it's "design or potential" performance.
This is not a Tune-Up Special or a maintenance service. It is not an inspection or refrigerant charge check.
When our trained and certified service professionals have completed the system profiling, we will :
1) Review with you the profile resultes
2) Offer the necessary correction and solutions to increase your systems effective efficiency to the best it can be.
b) When we are completed with the work, we will again "Score" your system. This is verification or final test results.
It is typical to improve a systems performance by 20% or more, depending on how poorly it is operating.
Call today for an appointment, and get started saving money, energy, and enjoy greater comfort . You'll be glad you did, and remember with a 100% Satisfaction Money Back Guarantee... "You Just Can't Lose!" |
